Activity Stream

Carbs are OEM with Shindy rebuild kits in both. I was also thinking carb issue, but the fact that I have black plugs and can't make it run too...

You mention they will throttle up fine with the choke on so it sounds carburetor related to me . What brand carburetor kits ? A lot of cheap kits...

débile tes bikes! j'Adore ton tri-z il a l'air clean en maudit!

That's what I suspected also, so I tried that. No luck. Still having black plugs, still not running well. I have a suspicion that it may be a...

Yeah Footy I was going to suggest the same thing , if your needing the choke on to accelerate then its wanting more fuel . Try lowering the slide...

I have a 1983 110 that was a barn find. After I went through it and got it running it ran poorly and would not accept throttle input very well. ...

Man, I need to get there one of these years. Great pics, thanks!

Factory airboxes with Uni air filters.

Are you running the factory air boxes or just pod filters ? 110s are very sensitive and need a complete factory air box to run correctly .

Yes they will throttle up slowly okay. After the RPMs are up, I can be more aggressive on the throttle, but from idle, fast movement on throttle will...

Can you throttle them up slowly? Do they only bog with fast throttle movement or all the time? The farther you back the air screw out the leaner...

Fixed! Was just a poor negative battery cable connection at the battery.

If you are talking about dragging 300lb shot up hogs and maybe a trailer, I would go for the Big Red 250. Especially since it's an 87 and the last...

I still check in pretty regularly. Been on here since 2010. I wish the forums would replace facebook pages.

i've run through the timing a few times. i haven't pulled the flywheel in a while but i'll double check to make sure the key is in one piece. it does...

That carb looks like a true Kehin. If it is a china copy it is a darn good one. Does the knock iterations increase with the rpm of the engine? I...

it needs a bath. one thing i found was the tool kit is still in a cover under the seat.

ok i sortet it out the Problem was the adjusting screw and the clutch pressure plate alligned with the arrows, works now. thanks

I was assuming it was a 3rd gen liquid cooled 250R. You machine is BEAUTIFUL! Because it is a 1st gen, it is actually worth less than what I told...

ok i think i instaled the clutch cover plate not according lining up with the arrow.... i will take a look cebaise there is no play in the clutch...

Thanks for this Advice, yes its moves, we take a look with my endoscope cam, see Video here if the clutch pack moves enough clutch discs looks...