Activity Stream

A little bit of info here and there on the Facebook page.

Effin trees. Had a buyer coming. Warming it up. March 96

Ice fishing. Lockport Manitoba. January 96

Back when you couldn’t give them away. CAD

Low carb diet

4u3 is the prefix for an '81 YT125H (last letter of the model is the year identification, 125s started with G in 1980 and go in order from there)....

One of mine is cracked too. Well, mine are stacked nuts but the ones I just got one of those is cracked.

Thanks again J!m :cool: Looks like I need a decompression cable… oye. Where do go for that? Also made some new motor mount bushings to...

Stayin warm and dry, now.

Good idea and nice inexpensive fix.

So as a last ditch effort I took a chance and ordered a choke plunger for Keihin PWK series, these can be had on ebay for around $10. You will only...

For bikes that aren't garage kept to keep the corrosion/rust off the links and the O-rings soft I use ATF (auto transmission fluid) just pour some on...

never lubed a chain in 30 years period, we run sand good chain no lube

That's not the issue. With the airbox lid on it will not run correctly. It runs pretty good without the lid. But you are right if I end up not...

The filter looks fine. It just needs rejeted to run with out the air box lid it’s getting to much air for the stock jetting

i have an update on this. The big red would not run perfectly with the airbox lid on. I believe this filter setup is so much larger than the...

I finally got around to installing this filter. It does fit but requires trimming off the rear filter mount inside of the air box. I hated to...

Did get pretty lucky I’m going to do some more work to this yz top end and make it even faster!

All good. I typically run wiseco too but the pro x at the time was a smokin deal. It lasted a good 3 years and had a lot of hours on it. Think I’m...

It might be worth saving potential aggravation as other failures are discovered… the seller may offer a “core” charge for your old one too.

Thanks! :cool: I attempted to clean the front brake caliper and ended up ruining the pin seals. They have been saturated in for oil for decades...

Looks good. Nice & tidy little workspace too!

Making way on the mighty 350X! Where is a good place to get a fuel petcock? Mine is a cheap Amazon one and it’s leaking.. haha.