Tecate flywheel tool

[luke]

I just got a flywheel puller from ebay, and it dosen't fit the flywheel.
Partly my fault for not looking first, but there are no threads on mine for the tool to go on to. I saw it and bought it without giving it a second thought. What do you guy's use or is there another i can buy ?

This is the one i got -

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=190309482972&viewitem=&sspagename=STRK%3AMEWAX%3AIT

[Tecate 50]

That tool is for KX flywheels.

[deathman53]

I used to have a homemade flywheel tool, it basically was a round piece of aluminuim 1/2" thick, it had three slots in it that the flywheel bolts into and the center has a threaded hole tapped with a 2" 10mm bolt that presses against the crank. It looked really easy to make.

http://pictureposter.allbrand.nu/pictures/deathman53/IMG_0867.JPG

[Yamaha_Rules69]

Hey jeswinehart, thats a steering wheel puller, right? Good idea....

[eyecekold1]

This works out nice it looks just like jeswinehart's tool. You can get these at Auto Zone and Harbor Freight for like 15-20 bucks.
http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=37824

[nd4speed]

I went to Autozone and bought a harmonic balancer puller.

[Maico]

I went to Autozone and bought a harmonic balancer puller.

That's the 1.

[Racerguy381]

Simple to make if you have some scrap metal a welders an a decent size nut an bolt. Drill a few holes or slot them for a multi use tool, one big on in the center. Weld your big nut in the center hole and I would gusset it on the sides so it doesnt warp. Some of them flywheels are on like a mother.... Simple enough

[luke]

Thanks guys, if this one fit's the Z i'll keep it. Looks like i need to find one like in John's pic :rolleyes: