200x seat pan warp

[TrailerRider]

So my 200x seat pan sat out to long in the sun (PO's doing not mine) and it made the front lift up instead of mounting flush to the tank. Is there any know method to fixing this? I recoverd the seat and with it bolted down the top has a rinkle. It is a rider but still..

[harryredtrike]

a couple of inch lift is normal in the 200x seat.you have a stretch in the seat causing the lift.mine does the same.

[shortline10]

Very common problem . I use a heat gun and put them back to original shape but I recommend doing it before you recover the seat .

[TrailerRider]

Very common problem . I use a heat gun and put them back to original shape but I recommend doing it before you recover the seat .

Heat gun. OK. Well when I get in the new shop I will redo seat than, till then I will ride it as is. Thanks for info.

[WIkid500]

Yep heat gun before you recover. If you can get a little pressure in the pan against the tank before you recover it the better off you are. Just be careful when you recover that you don't stretch the vinyl too tight and pull the front part back again.