idle problem on a84 200m won't stay running

[vtx rider]

wondering if any one knows why my 200m won't stay running,i have messed with these three wheelers for years.Ijust had the carb apart cleaned and checked everything,when i put it back on it starts right up but won't stay idling.It acts like it's getting to much fuel,i have to hold the throttle lever about a 1/4 open does anyone have any ideas.:mad: give me some input.

[haggard 2hundie]

ive had to clean my carb on my 200x 3 times now , looks clean but keeps clogging, bad or old gas was my culprit, maybe change your jetting?

[vtx rider]

I can try that or rebuild another one of my carbs and see what happens thanks

[trikes4life]

my buddys 84 200m has the same problem we replaced everything, plug, coil, stator, carb rebuild, come to find out it was valves.

[rdlsz24]

I was having the exact same issue on my 200x. I got so fed up with messing with it I bought a new eBay carb. Now it idles just fine. The internal parts of the carb get worn and too much gas gets by. No carb kit comes with a new slide and they are an arm and a leg at the stealer.

I'm going to be writing up a review of the carb I bought shortly.

Rob

[haggard 2hundie]

I was having the exact same issue on my 200x. I got so fed up with messing with it I bought a new eBay carb. Now it idles just fine. The internal parts of the carb get worn and too much gas gets by. No carb kit comes with a new slide and they are an arm and a leg at the stealer.

I'm going to be writing up a review of the carb I bought shortly.

Rob
im having troubles with the slide in my carb sticking, any sugestions?

[rdlsz24]

Try some WD-40, that's what I have used in the past.

Rob

[haggard 2hundie]

wd-40 just spray it into the top o the carb ? i have a twist throttle and the cable may be too long not sure if this is why its binding up

[rdlsz24]

I normally pull the slide out and use my fingers to coat it with WD-40. I would look into that cable

Rob

[haggard 2hundie]

thanks ive had troubles with it in the past but growing up on dirtbikes the thumb throttle seems unatural to me, maybe i should just go back to the thumber ? or just a shorter cable for the twister, it has a metal cable housing with a 90 degree bend where it goes into the carb and the bushing is worn and wont hold it in place , i have it secured now with electrical tape not sure how long it will last

[haggard 2hundie]

sorry for stepping on your post here vtx i am just desrarate to get my trike off the porch , maybe some of this will be useful to you