Got 2 carb kits, how hard are they to do?

[TeXaS SoB]

I just got a carb kit for my 200s and my atc70. Ive never rebuild a carb before so im a little scared lol. Im pretty mechanically inclined but was just wandering how hard they are to do and how long it should take me to do each one? I also noticed it seemed like the kit for the 70 had more parts than the 200 whats that about?:crazy:

[QCR77]

if youre mechanically inclined then it'll be no prob. just be real careful when you take it apart and if youre gonna use compressed air then be careful with that too. i was a little tenative at first too, but its not bad at all.

[Mr_RPM]

it may help to get a manual with some carb diagrams in it to reference by, im sure something can be found online. but yeah it wont be hard at all, one thing i have learned is dont start something then leave and comeback later to finish it when its your first time. makes it hard to remember what goes where and stuff.

[AutoXer]

get one of the carb cleaner buckets with the screen/pail inside they are awsome. Take out every thing on that carb and put it all except the rubbers into the cleaner and let it soak . You can usually just wipe the varnish and gunk off after that .. as far as time ? This is your first time and if you let the parts soak for a hour i would say you could do 1 carb in 3 hours if it is real dirty

[TeXaS SoB]

ok thanks im gonna have to await and tackle this on a day off.

[haggard 2hundie]

ive noticed some carb kits come with the floats and some do not, if everything else is replaced why not the float or am i just overlooking something obvious ?