1985 Honda 250SX Racks??

[Adam6604]

Hi, im adam. im new to 3wheelerworld. i personally own a 85' honda 250sx. in my family there is also a 1983 Honda 200Big red and a 1985 Honda 250ES big red.


i currently own a honda 250 sx in greeeaat shape, id like to have a set of rear racks for it, when im digging in the mud.
but i can't find any ANYWHERE. anyone got any suggestions?

[tri again]

Hi, im adam. im new to 3wheelerworld. i personally own a 85' honda 250sx. in my family there is also a 1983 Honda 200Big red and a 1985 Honda 250ES big red.


i currently own a honda 250 sx in greeeaat shape, id like to have a set of rear racks for it, when im digging in the mud.
but i can't find any ANYWHERE. anyone got any suggestions?

somewhere on here are the old orig sales brochures that gave pix

I've also seen some that look like the old 110 racks that have braces down to the trailer hitch area

are those HOLES i see in your fender seat area? like for the racks?

[oldskool83]

someone added a headlight gaurd and extra support on the orginal rack. i got very nice hondaline racks on mine

[Adam6604]

yah those are holes for the rack he said , my ... 4th cousin i think? originally owned it since knew, he had the rack but he lives hours away from me.

[Escanabajosh]

if he's still got it i'd get his, there hard to come by. i got lucky with a CL wanted ad for mine.

[Silverado]

Hey Adam, i can give you measurements or something if you can make one, I have a set of front and rear for my 250sx

[Adam6604]

ya man ! i could try that, could you send me a picture of them?

[Dirtcrasher]

I also can make them from 3/4" thick tubular steel. I have an 87 250SX to test if it on.

I designed mine to bolt to the the rear grab bar so no holes get drilled into the fenders.

Any size/width can be made. It can be made in a 1 piece unit or so that it bolts together to the grab bar and sides of the machine. I set mine up to run a PRM grab bar but anything can be configured.... Mount it to anything you wish!

I'll try to dig up a pic of my rack, but right after I built the motor with 700$ worth of performance products, I put it away. Sure it gets to 50MPH faster but then top speed is ALWAYS limited to about 50MPH. They are a very fun trike and next on my list was a modded manual clutch.

EDIT - It is/was never my intention of "stealing" work from someone else, I had not read the whole post.... I merely prefer tubular DOM tubing over flat stock and angle iron. Then you have to paint it all up and I recommend Rustoleum right from the can and applied with a brush. It lasts YEARS!! and the rack won't fit within my PC oven... :D

Sorry SILVERADO!!

Good luck!!