clutch problems

[ronniecarrigg]

200x new clutch slipping installed correctly am i suppose to soak it in oil springs are new is it suppose to get oil on it help please tired of taking it off it works for a bit then starts slipping

[Yamaha_Rules69]

Yes, before you install the new fiber plates the first time, you are supposed to soak them in oil. Did you replace both the fiber and steel plates? Are you sure your clutch is adjusted properly? There should be some play at the lever, before the cable begins to move when you barely pull it in. You can adjust from the lever screw, and there is also an adjuster on the lower front right side of engine. Make sure there is play in the cable, and that the clutch cable is routed properly, so that it dosnt move the cable when you turn the bars, before you tear it down again. Good luck!