handle bar for 1985 250R

[riverrat]

Well I wiped out last June, and now it's time to fix her up for ice racing. I am open to suggestions for the following:
Handle bars
Clutch handle + brake handle.

I am also going to remove my twist throttle, and put the thumb throttle back on, just need to figure out what cable to get to go from the stock thumb thorttle, to the mukuni carb I got from ESR.

I am not looking for the best stuff, but not the cheapest either.

Ice tires and screws are on the way!

[beets442]

If you can find older Answer's they fit the 250R well...Beets

[riverrat]

Looking for new stuff, but if the deal was right I might buy used. Forgot to mention, the handle bars should be low profile, for ice racing.

[audioworks04]

any 7/8 bar will mount up perfect. You just need to pick your bend. If you want low, I would probably buy a set of renthal cr mid or hi bend bars. As far as clutch and brake levers, everyone loves asv's, but I personally think they are over priced. I love my sunline clutch perch and lever, but it is also pricey. RTC used to make some really nice levers and perches that I run on my R, but they are hard to find. MSR makes an okay clutch lever, the raptor, but I had problems with it falling appart. Kinda just like everything else you get what you pay for.

[willrideanythin]

I have a few sets of bars, 20 will ship you a pair of low aluminum ones. I have several bends, sizes and materials. PM me

[SUPERBEAST]

what about handlebars off a new crf bike?