PDA

View Full Version : 300 ex g force axle in 350x


SonicTronics
03-03-2011, 09:34 PM
From what I understand it will fit but will also be shorter. How much shorter is it than stock? If I set the axle to be +1 and used my current extenders +4, how close would I be to where I am? I guess the better question would be whats the difference in width stock for stock with the 300ex axle and the 350x axles? Thanks.
jason85atc250r
03-03-2011, 11:45 PM
when you do this swap you need to get the 300ex hubs and sprocket.

The g force axle is a +4 for a 300ex so with the hubs it'll be 4" wider then with your originap 350x axle
SonicTronics
03-04-2011, 12:01 AM
So essentially what you are saying is that a gforce axle for the 300ex will be the same width as a stock 350 axle? Or will the width be the same once you factor in the standard 350x hubs and the standard (yet wider offset) 300ex hubs? Thanks for the reply.
jason85atc250r
03-06-2011, 11:17 AM
no it'll be a +4 when you use 300ex hubs. YOU CANNOT reuse your 350x hubs wrong splines.
SonicTronics
03-06-2011, 12:12 PM
Ok thanks. I know I need the 300 hubs, I worded that part pretty poorly. I coulda sworn someone on here had a 350x axle for sale but I cant even find the thread now, I must be losing it.
bkm
03-06-2011, 12:39 PM
Ok thanks. I know I need the 300 hubs, I worded that part pretty poorly. I coulda sworn someone on here had a 350x axle for sale but I cant even find the thread now, I must be losing it.

That was my thread. The axle is in pretty bad shape and I'm keeping the rest of the parts for sale so I had the mods delete the post. Your not losing your marbles.