torque for exhaust manifold - 86r

[mohadib]

Howdy
The Clymer manual doesnt have the torque spec for the bolts holding the exhaust manifold to the cylinder. Can anyone tell me what it is please?

Thanks

[mohadib]

Hmm dont see the spec for the bolts holding the intake boot/reed assembly to the cylinder either. Can someone post those too?!! Thanks!

[Dirtcrasher]

What are they, 6MM threads?? There should be a general torque in the book for fastners not listed.

If not, google "general torque 6MM/8MM etc etc" it isn't much, I have to use my 3/8ths torque wrench on those and convert to inch lbs.

Intake gets a criss cross pattern a little more each pass to prevent warping.......

[mohadib]

ah, thanks, ill check the book tomorrow when im back at the shop. thanks!