PW50 Motor in Tri Zinger YT60?

[stevensj13]

Theres a guy on craigslist that has a PW50 in pieces, but it has a new top end. I am thinking of picking it up for the engine, because my tri zinger engine is in need of a LOT of work and i heard that they are the same engine besides the top end. If I can just bolt in the PW50 engine and run that until i get my other engine finished that would be great! Would the PW50 engine fit?

[84 r]

iv heard that aswell

[stevensj13]

Well i recently pulled the zinger back out of storage and am still curious about this. Does anyone know if its a bolt up swap? And also, do i need the drive shaft from a pw50 too or are they the same too?

[Jon Boy]

should be a direct bolt-in. shafts should be the same too. also there's a few moped's that share the same motor and if you can find a mj (Towny) motor you can have an auto 2speed trans (not exactly a direct bolt-in though for the 2speed). :beer