Which clutch perch/lever for 350x

[twitch101]

For my build im doing im looking to revamp everything. I was looking at either this asv lever
http://www.rockymountainatvmc.com/productDetail.do?navType=type&webTypeId=189&navTitle=Handlebars-Control&webCatId=12&prodFamilyId=24217

Or this one but it says motorcycle only :wondering not sure how it matters.


http://www.rockymountainatvmc.com/productDetail.do?navType=type&webTypeId=189&navTitle=Handlebars-Control&webCatId=12&prodFamilyId=9420


If there are better options please advise me

[RIDE-RED 250r]

I like the ASV better. Not entirely sure why the other would be motorcycle only....

[dcreel]

ASV levers are very nice..

[twitch101]

The asv makes a matching lever combo for the brake too but for some reason they rmatv says it wont fit my bike. Is there site just misleading me?

[Dirtcrasher]

I got some for about 14-40$ while watching auctions on EvilBay (ASV that is).

I don't waste the weight of a parking brake, ( and they seize :lol: ) So I didn't run them. You should get a long front and that puppy should fit a couple machines. Run it a high loop above the top crosspad and or headlamp.

[dcreel]

The asv makes a matching lever combo for the brake too but for some reason they rmatv says it wont fit my bike. Is there site just misleading me?

I looked and didn't see anything for a 350x. They do sell an asv set for the 87-89 Fourtrax 250r/250/300/400EX. I don't know if the master cylinders are the same between the 350x and the trx250r. You may have to do some research on that. I bought a blem ASV lever on Ebay for $20 and made it fit on my '84 Tecate. For the '85 Tecate I bought the ASV kit for the Banshee and bought a used polished Master cylinder off Ebay to make that work for the front brake. The Tecate clutch cable works in the Banshee clutch perch/lever.

The asv levers just feel good to the fingers, and they move out of the way in case of a roll over.

http://i176.photobucket.com/albums/w182/dcreel/011-9.jpg

http://i176.photobucket.com/albums/w182/dcreel/Tecate/asv005.jpg

http://i176.photobucket.com/albums/w182/dcreel/Tecate/asv002.jpg

[twitch101]

I have a 400ex master im going to use. I just wanted to make sure they would work. As always thanks for the help guys

[murfman]

I bought a brake perch with a short hot start lever that I am going to use for the compression release on my 350x. I am running a Goki so this way I don't have to engage the kick start to use the Goki, the lever is right behind the start button for one handed operation.

[twitch101]

Just to verify, using a 400 ex carb and master. Are the throttle brake and clutch lengths the same as 350x? Is there different style cable ends?

Or would i be fine running 350x cables

[murfman]

400EX carb and master on mine as well. Stock cables fit just fine.