200x rear width

[Tecate Karl]

Ok picked up a 84 200x for 100 last week kinda rough but I've seen worse but my question is does any one no the stock width on these things this one is really wide it's at 50in it's wider than my 450 and my 250r. There is no spacers so does any one know if this is a stock or after market axle I don't see any markings so I'm asking the experts.

[xrider]

I own a durablue, NASA, and Finishline Rear axle for the first gen 200x. If you post pictures, I can identify it for you.

[yaegerb]

I 2nd Xrider's comment. If I had to guess, it’s a finishline....they measure 39.5 hub to hub. Add in some inches for each wheel and you get approx 50-52 inches. Here are a couple pictures of my finishline.

146924
146925

[JJMF1979]

If it is 50 inches then it is definately an aftermarket axle or hubs or both

[Tecate Karl]

Ok I'll try to get pics tomorrow when I get home weather is crap today. Well I'm glad that I'm getting some where on this also it has a metal braket for the head light does any one else have one of these it doesn't look oem.

[oldskool83]

stock width was 42"

if you add offset rims your will be 44"

if you add 250x/300ex/400ex hubs you will be at 45.5

dont add spacers axles to week.

i run a +4 82 250R durablue axle in mine, im 50" wide.

[Tecate Karl]

It dosnt have spacers and the rim offset don't look extreme.

[oldskool83]

why not post a pick. with out a pick everyones guess is as good as pissing into the wind

[Tecate Karl]

why not post a pick. with out a pick everyones guess is as good as pissing into the wind


I agree it's just been rainy here so if it dries up some here I'll go get some pics.