saving the rings?

[tapage]

how can you save your rings without taking your motor apart, is there a cleaner you can run through it, me and my friends went swamping and went romping in the creak, i went to there house came back to leave and it started bellowing smoke... any tips would be apreacited i can send it and the top end off for a little less then 300

[tri again]

Hard to believe and MAY be an urban legend but back in the 70-80's
porche and vw's would come to the dealer smokin' so they mix up some comet cleanser
dump it into the cylinders and spin them with the starter
and then rinse them out somehow.
It would help the rings seat.

The hardcores would just tap comet or bon ami dust into the intakes
as they ran to get the rings to seat.

Sounds like yours is a little more than a glazed cylinder.

Best of luck.
Maybe a simple oil change is a good start?

Maybe gas ran into the crankcase and diluted the oil during your break?

If it was generally healthy before and you happened to break a
ring from sucking a little water, rings, gaskets aand a ball hone should
do wonders for cheap.

Hopefully it was just white steam from a wet exhaust packing.

[tapage]

its been doing it foe a couple days now, thanks
Travis