PDA

View Full Version : ATC110 Rear Axle Installation


KI4UJO
06-30-2012, 02:19 PM
Well, I thought I would get to ride my 110 today, but then I threw my chain, again. After studying it, I believe that my rear axle is not seated properly. So, based off these photos, is it? If it's not, how do I install it correctly?
http://i1225.photobucket.com/albums/ee392/KI4UJO/GEDC0495.jpg
http://i1225.photobucket.com/albums/ee392/KI4UJO/GEDC0496.jpg
remsandpets
06-30-2012, 07:43 PM
In not an expert by any means but it looks like the chain is very worn. Is that the case?
KI4UJO
06-30-2012, 11:04 PM
It's worn, but not so excessively that it would jump off. I may have fixed it, and I'm setting my alarm for 5am to fix it (It's going to be 105 tomorrow). I believe I installed the main drive gear on the wrong side of the mount.
remsandpets
07-01-2012, 09:16 AM
Good luck in the heat. As others here have said, if you are replacing chain you should do both sprockets as well. Least I remember reading that somewhere here.
shortline10
07-01-2012, 10:10 AM
I believe I installed the main drive gear on the wrong side of the mount.

Yep the sprocket is on the wrong side of the sprocket hub .
KI4UJO
07-01-2012, 11:30 PM
I reinstalled it, to find that the arm that is bolted to the frame to tension the chain, along with the shaft that it slides into is rounded off. So, now I have to buy that. However, everything now lines up.
shortline10
07-02-2012, 06:16 PM
I'm not real sure But I believe I have those tensioner parts . The 83 is an odd ball year but I believe its the same as the 90/110 older models .



I reinstalled it, to find that the arm that is bolted to the frame to tension the chain, along with the shaft that it slides into is rounded off. So, now I have to buy that. However, everything now lines up.
KI4UJO
07-02-2012, 07:22 PM
Yes, it's the same as the older years.