View Full Version : P3 Wheelies
M.Pargiello
03-07-2013, 11:24 AM
My brother and I were out on the trikes this weekend, So he started ripping some cheater wheelies on the P3. I had the go pro going so I snapped a pic of the screen while watching the video. We were also climbing a snow hill as well, I may post the video if I get bored enough. Yes, he is wearing a helmet, but it is cut off at the top of the screen.
164531
hawaiirider
03-07-2013, 04:35 PM
sweet trike!!! will it do regular wheelies? dont know much about them
Howdy
03-07-2013, 05:34 PM
You can get them to wheelie while sitting on them I did it quite a few time last year at TF ( there is a trick ). How ever it's pretty hard on the drive belt, by the time TF12 was over my belt was slipping. The belt was only 6 months old. LOL $36 a belt, and a crap load of time to install.
Howdy
M.Pargiello
03-07-2013, 11:38 PM
Yeah, to pull them off while sitting is a little difficult. The power doesn't snap in instantly so you have to anticipate it and give her a good yank.
Howdy
03-08-2013, 12:27 AM
Yeah, to pull them off while sitting is a little difficult. The power doesn't snap in instantly so you have to anticipate it and give her a good yank.
Hold the rear brake tight. Full throttle on the motor ( it will bog down ), release the brake and hold on. The drag on the belt will cause a little wear and the P3's will let you know if there is a little wear on the belt. LOL
Howdy
M.Pargiello
03-08-2013, 03:21 PM
I need my rear caliper fixed or replaced. It is hard to pull. Ripped it apart a few times and cleaned it but no luck
Howdy
03-08-2013, 05:28 PM
I need my rear caliper fixed or replaced. It is hard to pull. Ripped it apart a few times and cleaned it but no luck
Most of the time the cable is the cause of the problem. If you was here I would have the brakes working like new within a hour. I have done enough of them to get real good at it. LOL
Howdy
Howdy
03-08-2013, 05:33 PM
If you wanted in a few weeks we could meet in the middle ( White Pigeon @ John's with his permission ) and I could fix that rear brake. I need to get back to John's soon any how. ;)
Howdy
M.Pargiello
03-08-2013, 07:30 PM
I may be able to, but if not, it will be at trike fest for sure. Have at it haha. I have just been focusing mainly on my Hondas and the KX
just ben
03-09-2013, 08:54 AM
My polaris wheelies without any brake action. At about 5 mph hammer the throttle and give the bars a slight yank and she stands right up. I don't recomend it without rear brakes though,with no engine braking your screwed if it comes up too far.
jeswinehart
03-09-2013, 07:05 PM
Any time gentlemen, any time.
fla 2-stroke
03-10-2013, 12:45 AM
I have no problem ripping the front end up on mine.I mean its no 250r but just get the rpms right,hit it and yank the bars.comes right up.
M.Pargiello
03-10-2013, 01:47 AM
Ours is far from perfect so I'm sure it could use a new belt. After a good spray with some belt conditioner it will do it fine while sitting on it.
Powered by vBulletin® Version 4.2.2 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.