Atc 110 Snorkel

[Bankersbank]

Is it possible and worth it to snorkel an 81 atc 110. Because I would have to drill through the frame to run the snorkel up to the handle bars. Has anyone done this to their 110?

[ngunter2]

Ive never had a 110 but if you have the original intake it probably runs high just like all other three wheelers. I was thinking about doing this to my 200x auto because it was missing almost all of the intake pieces. I was going to run it right out of the carb :) haha. If you do do this I would say figure out something to keep from drilling that frame. Run it out the back maybe?
169230
Maybe this will give you a little idea to think about

[Bankersbank]

It mounts to the frame just a few inches above the rear tire.

[ngunter2]

But it is connected to the frame and runs forward towards the tank right? Like this...?
169243

[Bankersbank]

Yes, it's very similar to that. I'm gonna use 1 1/2 pvc pipe for the snorkel because the original hole is 1 1/4 wide. Is that enough or do I need to go bigger? And will I have to rejet?

[ngunter2]

If It is Similar to that then The intake is already high and pulls the air in right by the handlebars. If you snorkel I would run your snorkel off the back so you don't have to compromise the frame like the earlier post. (this is how I would do it... Just spit balling) Close the old port to the frame if it happens to suck water. Cut a hole in the air box 1 1/2 diameter. Use threaded pvc pipe and then wedge the air box between 2 pvc pipe nuts. Seal that with some type of silicon gel. Then it is up to you to build around the frame :). That size is fine. You wont have to rejet. It could change the air flow but it wont be significant so maybe a little tuning. What was your idea on how you were going to do this?

[fcf35]

Just throw on some fatter tires.she'll float and you wont need.a snorkel.