Pic request....350x rear brake hub

[knsmodels]

anyone have a good rear brake hub that they could snap a few pics of?? want to compare to see how beat up mine is.....and dimension of the race area that rides on the seal would be a plus also....Thanks in advance

[Dirtcrasher]

Rear brake hub?? I'm confused.....

Any parts fiche will show it online.

Do you mean rear brake disc rotor hub?? That seal area usually holds up, the axle OD (seal or bearing area) gets worn from lack of lubrication. I'm sure I can measure one but the shop manual should have the tolerances.

Sometimes I turn them down on a lathe and pop on a little sleeve to get them up to spec..........

[TecateDan]

DC is confused? I doubt it

[TheBlueWale]

http://www.ebay.com/itm/Honda-atc-350x-ATC350X-rear-hub-and-brake-rotor-85-86-/350800055743?pt=Motors_ATV_Parts_Accessories&hash=item51ad500dbf&vxp=mtr

The center piece, I don't have one to send a pic of, but you can always look on ebay.

[knsmodels]

The hub in the ebay ad is correct pc but I need to see the other side....I didnt see any tolerances in the shop manual but I will look again....Thanks

[knsmodels]

http://www.knsmodels.com/images/hubs.jpg

alright hub on left is sprocket and right is brake.....are these salvagable??

[Dirtcrasher]

Well, it's possible but probably easier to pick one up here in Classifieds.

Not fun turning it down to good stuff and then pressing on a new sleeve. Machine shop work isn't cheap.

If it was unobtainable, you would have to repair it.

They look terrible, no grease the axle tolerance is probably shot too.

The sprocket hub looks homemade be a perfect circle.

How are your axle splines and journals??

Hanes/Clymer/Honda shop; One of those must have the tolerances.

As it is, any water will fly right pass the new seals which will be ruined immediately.......