83 ATC 110 rebuild assembly question..

[kbags948]

Hi Everyone,

I need some help with the placement location of the base gasket o-rings for an 83 ATC 110. Manual says that model years can vary. I must not have been paying attention when it came apart to keep track of where they go. Thanks y'all!

[hatc200x1]

http://www.westernhillshondayamaha.com/OEMpartfinder.htm#/Honda/ATC110_A_(83)_ALL-TERRAIN_VEHICLE_(ATV)%2c_JPN%2c_VIN%23_JH3TB020-DC400008_TO_JH3TB020-DC453423/CYLINDER_HEAD_%2b_CYLINDER/ATC110-83-JPN-A/2Y14943ZE14943Z03E
There is a schematic for you. I dont see any base o rings but I do see the head gasket o ring. Im assuming the base gasket o ring would go on the same stud as the o ring that goes on at the headgasket as that would be the stud with the oil passage. Hope this helps.

[kbags948]

Hey hatc200x1,

Thank you for the info.! I ended up finding a nice exploded view of the 83 engine. I didn't see them on there either. Turns out they ended up being the small O-rings that seat beneath the valve guides, which I never removed so of course I had them left over.