Some BW Frosting

[Six Stroke]

Always use protection.

187556

[kb0nly]

Very cool... Looks pretty beefy.

[kiser]

Looks good! I'm guessing you made it?

[Six Stroke]

It's actually the Moose plate for a TW200. Bolts right up.

[JasonB]

very beefy looking!

[Six Stroke]

The original plate was missing from my basketcase BW, so I did some checking and found that the OEM BW and TW plates have the same part number. So, in case anyone is wondering before they go and spend the money, yes, the Moose TW plate is a direct bolt-on for both the non-electric and the electric start BW200.

[kiser]

Thanks for the good info! I mite have to pick one up. That would take a beating way better than the OEM plate.

[Six Stroke]

The only issue I encountered was a small wire loop attached to the frame cross-tube that goes between the footpeg mounts. I would assume the loop is there for the vent hoses, but it was in the way of the left-rear clamp on the Moose plate. A few seconds with a hacksaw blade fixed that problem.

[BWSwamper]

What is the particular Moose Racing part number for the skid plate you used?

[Six Stroke]

This plate here:

http://www.mooseracing.com/products/?productId=114451&productGroupId=1148&partNumber=05050965

I ordered it through my local Yamaha dealer.