ric
07-04-2014, 07:06 AM
Hi All
Has anyone struck this problem before, trying to fit a new Maier Fender to an 83 ATC110 (same as ATC125M)
The seat pan sits up high on the fender, the new fender doesn't have the tool box as OE but has a rise where the tool box normally goes. The seat pan sits proud on this rise and misses out on bolting down onto the fender by about 25mm.
Sorry if all this doesnt make a lot of sense, I am trying to help out a friend and this is how it was explained to me.
Appreciate any help or advice.
Cheers
Ric
Has anyone struck this problem before, trying to fit a new Maier Fender to an 83 ATC110 (same as ATC125M)
The seat pan sits up high on the fender, the new fender doesn't have the tool box as OE but has a rise where the tool box normally goes. The seat pan sits proud on this rise and misses out on bolting down onto the fender by about 25mm.
Sorry if all this doesnt make a lot of sense, I am trying to help out a friend and this is how it was explained to me.
Appreciate any help or advice.
Cheers
Ric