View Full Version : 85 250r problem bogging
slippery
02-17-2019, 12:25 PM
Rebuilt motor and carb starts and idles fine but Boggs down when hit wot . No difference when u adjust air screw in or out ..help please?
Sent from my SAMSUNG-SM-J320A using Tapatalk
yaegerb
02-17-2019, 01:42 PM
Need more information than that. Need details of rebuild and details of carb.
shortline10
02-17-2019, 02:22 PM
Did you install an aftermarket CDI lol .
yaegerb
02-18-2019, 12:33 AM
How dare you ask for more information from Slippery ...........this is an exercise in ball busting........you figure it out ........and then it`s your fault the bike runs bad ........whats a leak down test ?.........i don`t need that !!
I have so much to learn from the great glamster. 1000 Hail Marys in order for me kind sir.
atc300r
02-18-2019, 11:06 AM
Try another coil.
hovel
02-18-2019, 12:07 PM
Does the engine bog and quit entirely or is the bog momentary where you can throttle through it and the engine runs OK ? Put a fresh plug in it, get it to bog and them pull the plug. If the plug is dry the problem is likely fuel-flow. If the plug is wet, perhaps there is an ignition problem. The air screw only controls low speed mixture and has almost no effect at W.O.T. Good luck.
captainweezy
02-18-2019, 11:27 PM
Didja look at it? Ya just gotta look at it.
Powered by vBulletin® Version 4.2.2 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.