200x Mikuni Intake Manifold Needed

[ZachH]

I am closing in on my 200x build, however I have purchased a mikuni 28mm carb for it and I need the intake manifold that converts it to a spigot type carb.
Thanks in advance.

[Dirtcrasher]

There's quite a few ways to attack this, not sure if the length is also an issue??

Anyhow, that's just a few MM's above stock, in the past I have use my dremel with a large sanding disc on it and carefully went in circles to bore it out enough; You have to be good with hand/eye coordination...

Honestly tho, Shortline10 is your best bet, he's the 1st gen 200X master....