Tri-Z/Banshee/Raptor Axles

[Billy Golightly]

I'm pretty sure I've heard that the Banshee axle interchanges with the Z, so that means the Raptor one should too, right? The axle under my Z has pretty worn out sprocket hub splines, so I'm looking into a new one. I'd like to get an extended one, so that leaves me to pick something up from one of the yammi quads. My question is about the sprocket hub itself. Since my hub is probably worn as bad or worse then the axle, it'll need to be replaced. Can I use a banshee or raptor sprocket hub on this axle, and it be the right spacing from the bearing carrier and what not? Will the banshee/raptor sprocket hubs have the same bolt pattern for my Z sprocket? The Tri-Z wheel hubs will fit right on there too, right?

[TimSr]

The Banshee sprocket holder will work, and is the same, (but I think it looks better). The Banshee axle is the same. The rear brake disk holder/carrier from the Banshee will NOT work on the Z. Im Raptor experienced deficient.

[Billy Golightly]

Thanks TimSr, thats the info I was looking for!

[mike from long island]

i have a LSR +4 banshee axle and banshee sprocket hub and sprocket on my 85 Z. never a problem. as for the crapter i too am not familiar. best bet is go with the banshee assembly. i also run banshee hubs. i own a banshee and warrior so i have many extra tires. now i bought that 350x and have no spares for my poor honda. time to switch to honda i think lol