PDA

View Full Version : help with boring


TrikerR
10-04-2004, 11:03 AM
i was just wondering what the limitations of the 110 cyclinder are. would be able to handle the 3mm increase to 125 specs or even the 9mm increase for 185. say if i did go for either one i was just wondering what other steps i would have to take for it to all work ad would i need a new rod or anything else.
anyhow, thanks alot for your time.

regards, ned morris
OldSchoolin86
10-04-2004, 11:16 AM
The 185 definataly won't fit and I'm not shure about the 125.
MTS
10-04-2004, 11:58 PM
I THINK the 125 piston would fit since iv herd thata cb 200 twin piston fits and its 5mm larger..
TimSr
10-05-2004, 08:53 AM
Ive never seen a cylinder that could be bore more than 2.5mm. Most two strokes max at 2.0mm, and most 4 strokes considerably less.
OldSchoolin86
10-05-2004, 11:01 AM
Ive never seen a cylinder that could be bore more than 2.5mm. Most two strokes max at 2.0mm, and most 4 strokes considerably less.
I agree that's a lot but the 400ex goes 3mm over.