Can you identify this kick lever?

[animal]

I have a kick lever that was on an ATC350X and it worked. But it's not a 350X, can someone tell me what it's for as I would like to put it up for sale. I think it might be a ATC250SX. Here are 2 photos and one has the demensions drawn on a piece of paper. If sone one could e mail me or PM me that would be great. Thanks


UPDATE: I looked at the lever and compared it to a ATC250SX and it's different. It is identical "except" for the 20 degree bend in the last 2 inches of the lever. I have added another photo. I hope everyone isn't tired of looking and guessing. Thanks again for any info.

[TimSr]

Thats identical to a TRX250 which I believe is the same as the 250SX, but not 100% sure about the latter.

[atctim]

Looks to me like an 85 - 86 - 87 Big Red Kick Starter from the looks of the block with the splines in it.

[Lomax]

Iwent and looked at my 250sx and the kicker is a little different than that one. I also checked out my 86 200x and my 83 200x and its different from both of them also.

[Dads]

It's a 200x 83/85. unless it fits a small shaft. then it may go to a XR200.

[GreyhoundRugby]

Im not thinkn 200x, 83-85 have a ribbed lever and its a little longer

[speed20]

Didnt the 83-85 200x's say "KICKSTARTER" right on the side of them? if its a 200x kickstarter, i believe its bent!

[stevo3176]

Look like a banshee kick start to me?

[deathman53]

250x, I have one at home, also trx250r kickers fit too, but will hit the cases.

[hotroddal]

i would have to say it is an 85-86 big red 250es kickstarter.

[speed20]

I tried to ignore steveo's post.....but i couldnt....the bashees have short kickstarters, and dont they have like a flat piece to put your foot on.....(maybe im thinkin blaster?)

[ThreeKing]

I agree that it looks like a Honda TRX 250X. :D

[TimSr]

If you actually look at his measurements, and the lower knuckle on this thing that extends it outward, and the sharp curve to it, it doesnt match most of the guesses posted, though it will probably fit on the shafts. For that matter it will fit on a TriZ shaft too, in an emegency, but that doesnt make it a TriZ kickstarter. Its very short and its sticks out at teh bottom and curves way in at the top which makes it work crappy on a lot of applications other than what it was designed for. I cant believe somebody was actually kicking over a 350x with that shorty!

If you are just going to sell it, and your are doing on classifieds, just list it showing your measurments and your price, and let the buyer compare measurements.

[speed20]

Thats an xr200 kickstarter (like an 80 something) i used to have an xr200 motor in a 3 wheeler that i had....and the kickstarters almost the same if i remember correctly.