jinxy
03-09-2005, 04:29 PM
i ave a ryoli or ryali 110cc quad its the same as the yamoto 110cc - but diff name well the cog on the rear has stripped a few teeth is there neway i can get the cog off? as it seems stuck 2 the axle! how can i get this off ive been told heat it with a blow torch + hammer it off! but then how do i get the bearin + cog back on?
SO - this is where my question comes! can i change it 2 chain drive instead of shaft drive - i think i would need 2 get a sprocket 4 the shaft on the engine + the rear - but would need a star shapped centre hold or something??
If i do this wot is needed 2b done? i dont wanna spend $$$ on a whole new rear end!
SO - this is where my question comes! can i change it 2 chain drive instead of shaft drive - i think i would need 2 get a sprocket 4 the shaft on the engine + the rear - but would need a star shapped centre hold or something??
If i do this wot is needed 2b done? i dont wanna spend $$$ on a whole new rear end!