can i get 10mm more out of my 110 cylinder.

[TrikerR]

i was just wondering if i could bore 10mm out of my stock 110 cylinder. i was just looking at it and it would leave about 3mm left on the sleeve.

[short4stuff]

so your saying theres like 6.5 mm of sleeve on those things?!?! .... (on each side..)
I think your trying to install a 125 piston?.. you could just use that cylinder..

[TrikerR]

no, im trying to install a 185 piston in there



edit- i was looking at the top of the sleeve, were it is about 7mm on each side. i just measured the width at the bottom and only 3mm. there goes that idea.
wait, it dosent matter, cause ive found a big bore high compression piston sitting on a shelve at my honda dealer. YAY

[MTS]

no, im trying to install a 185 piston in there



edit- i was looking at the top of the sleeve, were it is about 7mm on each side. i just measured the width at the bottom and only 3mm. there goes that idea.
wait, it dosent matter, cause ive found a big bore high compression piston sitting on a shelve at my honda dealer. YAY
you -could- swap a atc 90 cylinder on there with the high comp powroll piston...

[03 ORANGE SHEE]

i think the overbore is like 2mm max, i have never seen or heard of a cylinder wall being 7mm thick

[BIGCRIP28]

i think the overbore is like 2mm max, i have never seen or heard of a cylinder wall being 7mm thick

yeah that seems really thick to me.

[TrikerR]

didnt * read my post...i measured the top bit of the sleave, not the bottom.