Pull roap breakes

[Banage]

Every 3 to 4 times i pull it over. It is same size as old one, but brakes, where can i get high quality pull rope, this is clothen line, i think better rope woould do it.

[Yamahauler]

go to a hardware store, ask for pull start rope, they should have a bulk roll and just get 5 or so feet. They might even have differant thicknesses

[MTS]

get some nylon rope from the hardware store.

[yamahaman89]

but some nylon rope will strech out

[Oldshell4481]

any good rope will work as long as its braided, braided is tough, and has low stretch. just dont get it too small in diameter.

[Mobular]

Hit the local lawn mower repair shop, and buy the appropriate size there.

[bigredhead]

if your rope breaks after 3 or 4 pulls.. you need to follow it's path and sand/grind down some sharp spots.... something is cutting into it.

[Dave223]

if its breaking that fast, there is a sharp edge, probably where the rope goes through the housing, just file it down, or dremel it.

doh! someone beat me to it.....

[BIGCRIP28]

yeah, ditto on what dave said.
do you have the little rubber grommet deal in there?

[Banage]

nope, no rubber on it, maybie thats it

[honda110]

push start it. thats what i do

[MTS]

push start it. thats what i do
thats a major pain in the ass when you stall out in 3 ft of mud...been there done that hahaha!

[canadiandevil2]

Try putting a piece of aircraft cable. I had it in my bike for a bit but it started to fray from rubbing against a sharp edge. Its really strong though. just use the metal crimp things where you would usually tie a knot

[Oldshell4481]

i cant see metal as being good for the inside of the pull start assembly, it could mess things up later on