Transmission Needle Bearing

[bebeav]

anyone here could tell me where i can get the transmission primary shaft needle bearing??? magneto side. i really need this cause i can't finish my R project cause of that. this needle bearing is discontinued from honda and i cannot find it anywhere else also. help me please.


ALP
Beav

[Mobular]

Check with your local industrial bearing supplier. Look in the Yellow Pages. Take the old one with you so that it can be matched.

[bebeav]

they don't have anyone. this kind of needle bearing doesn't exist in quebec. i called 3 industrial bearing shop and approximately 10 dealer. i was more looking to know if anyone here could get some for me. i'Mll mail him some cash if he can get one. a used one could do the job.

ALP
Beav

[ATCWRENCH]

measure the bearing inside, outside, and length and I can check my local bearing shop. if they dont have it they can make it.

[bebeav]

i can't mesure the outside of the bearing he still in the crankcase. the only way to remove the bearing is to heat up the crankcase in an oven and hope that the needle bearing will come out alone.

i'll try to do this tomorow and get you the measurements.

ALP
Beav

[MTS]

ill see if we have any in stock tommrow at work,,,,if not ill find out the size and try n track one down. http://houseofmotorcycles.bikebandit.com/partsbandit/showschematic~dept_id~190810.asp
witch bearing is it number 12 or 13?

[OldSchoolin86]

they don't have anyone. this kind of needle bearing doesn't exist in quebec. i called 3 industrial bearing shop and approximately 10 dealer. i was more looking to know if anyone here could get some for me. i'Mll mail him some cash if he can get one. a used one could do the job.

ALP
Beav
:wondering If you haven't measured it how the hell can you know if anyone has it?

[bebeav]

it's number 13. my dealer took the measurement from the old one before removing it and we both called all these place should i said first. if i can remove my other needke bearing in my other crankcase i think i'll go again and try to meet some guys in the shop and talk with them to try to find if they can make me another one. hope it won't cost to much.

ALP
Beav

[MTS]

i cant get that one....but ill get the mesurements and see what i can find, i migt know where a used one is if worst comes to worst,...:\