new rims but 1 wheel still wobbles. what is bent?

[kilabeez0]

ok so i just put some almost new ITP rims and razr's on the 200x and the right side still wobbles just like the old rims did. I thought the rim was bent until these did the same thing. I have brand new wheel spacers on but I dont think that is the problem. Do * think the hub or axle is bent? Either way I've honestly replaced almost EVERY single part of this trike. Now I cant wait to sell it :naughty:

[bigredhead]

You need to setup a reference point from the ground and frame to that axle and figure it out....

Or sell it.

[350x'inNY]

Try jacking up your rear end, take off your rear rims and start the trike and put it in gear. You can see wobble in the axle better that way... If the rims aren't bent, I'd probably go for the axle... especailly if you have some large axle spacers on it... increases the leverage of the tires to bend your axle!

[Dads]

And by spining the axle you can see if the hub is bent.