Pull start repair.

[chris200x]

Ok a while back i broke the pull start rope on my 99 grizzly 600. I finally have it all dug out and am beginning to get it going again. the thing is I lost the original rope that was in there.

so my question is can i use any old rope or is there i specific kind that would be a bit more stronger or last longer.

Also i need to know how long the rope should be?

Thanks in advance for the help. :beer

[sblt500r]

don't just use any old rope. well you can but it will break when you need it. use a good nylon rope, of the biggest diameter that will fit. got to be about a 1/4 inch diameter rope that goes in there. you should get more than you need, its always easier to cut it, than have to rerope it all over again. i would say 5 ft would be more than enough. then if its too long, just cut it down.