View Full Version : The break-down
pinkerchook
04-01-2006, 10:58 PM
Here is some pics of my top end. It was not that hard to get apart, except for the head bolt that had to be drilled.
pinkerchook
04-01-2006, 11:00 PM
Here are some more. I will have it back togeather by next week. I wanted to know about the cam chain tensioner where the yellow screw driver is pointedon the top pics, that part goes just down into the side of the cam chain and into the top of the cylinder? There was so much crap on my piston top, its about as thick as 2 paper match sticks. The small cut pvc pipe I used as a spring compresser with a *Edited* clamp. It worked great.
ATCnut
04-01-2006, 11:15 PM
Looking good. Should run like a champ when you get it done.
pinkerchook
04-01-2006, 11:47 PM
I hope so. Hey has anyone noticed whats wrong with 3wheeler.org? I can not get onto that site.
hancadam
04-02-2006, 12:00 AM
There is a thread about this on the open forum.
Powered by vBulletin® Version 4.2.2 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.