Tri-Z clutch questions

[85ytz250n]

If you put your bike in gear and hold the clutch,with the engine off, will it free wheel:wondering ? Mine won't and i dont know that much about the Z so i figured i would come to the experts. If it isn't supposed to do that what are some of the problems that could cause that?


Keep the rubber side down.
Barry

[Erics350x]

Is your cable working?

[slothminx]

My one wont free wheel. And I think its common

[Bryan Raffa]

it should but it will be harder because your turning everything in the engine both of mine push hard too not running.

[85ytz250n]

O.K. that makes me feel a little better. So i am assuming that in order for the clutches to work properly the engine has to be turning. Yes my cable is working fine, a little stiff but the lube I just pumped through it should clear that right up, just giving it a little time to soak before i go out and test it again. So far i think it is $450 well spent, All it needed to run was the line to the back of the fuel pump replaced and it started on the second kick with choke on. I am going to replace all the hoses in a few minutes though, just wanted to come in get the answer on the clutch.

Keep the rubber side down.
Barry

[03 ORANGE SHEE]

neither will mine