help with 125m/ trx125 ring replacement

[Macs]

i just acquired a 125m with a 1985 trx125 motor in it. the motors look to be the same. Well anyway, the motor was locked so i let the top end soak overnight and today after fiddling with it for a little while i got it to break loose. to my astonishment this thing cranked up with a little starting fluid to get it going. i ran it for about 3 minutes and it died. i then could not get it to start back up. i had spark, had fuel then i was noticing oil seeping from the dipstick. when i turn it over i have tons of compression and oil comming out of the the dipstick hole so i must have broke a ring. now here is the question, how do you remove one of these top ends. i have never pulled one off before and i am kinda confused how to get the timing chain off. can someone please help?

[Macs]

come on, i know there is someone who knows how to pull a head on a horizontal style honda motor in here

[Macs]

i am down to the timing chain, How in the world do you get this thing off!!!!!! i am in dire need of help. i hope i dont have to pull off the side cover and remove it from the lower end. PLEASE HELP!!!!!!!

[Macs]

i figured it out and got it apart. the ring inst broke though. i am going to look into it tomorrow and see what it might be.

[kando]

I would say your float is sticking in carburetor and gas ran through cylinder pushing oil out thruogh dipstick. Just clean carb and you will be good to go.

[Macs]

i am having compression in the lower end .