another tri-z question

[Dusty]

ok if i dump out all the oil in my bottom end.....how much goes back in it...and also what weight should i use.....also what should i pre-mix it at......i ask these so i can get the best out of my bike.....
Thank you
Dusty

[Bryan Raffa]

theres a bolt just behind the waterpump on the the clutch case on the right side,take that out and fill it till it starts comeing out then you know its full. I use 80w belray motorcycle tranny fluid but 10-30 or 10-40 will be just fine.seeing how its summer now i would use 10-40, pre mix i would try 32-1 to start with, I run 50-1 with a highly modified engine and jetted correctly
If your still not shure on what bolt to take out let me know and ill try and get a pic.
here see right behind my silver waterpump cover and the bump out for the cluch baskit... thats the bolt! the lowest bolt on the waterpump cover is the one you drain your radatior fluid from if you ever have too.:TrikesOwn

[Dusty]

bryan is this the bolt you take out.....then fill it at the top....and when it starts to come out where the bolt is...i know its full....then when its runnin and spittin il out do i have to keep filling it every so often

[Bryan Raffa]

bryan is this the bolt you take out.....then fill it at the top....and when it starts to come out where the bolt is...i know its full....then when its runnin and spittin il out do i have to keep filling it every so often

yes thats it, its a good idea to check it often, just pull that bolt out and top it off before you do alot of rideing.. it shouldnt be spitting out anywhere unless you have bad crank seals,shift shaft seal or output shaft seal,kickstartshaft seal :D

[Dusty]

well i mean it spits out of the head where the muffle goes on....i heard they had a problem with that....thanks for the input

[Bryan Raffa]

thats just un burnt 2 stroke oil,not a big deal get a new exaust pipe seal and use some high temp silicone will take care of that

[Dusty]

so its not oil from my cases...hmm man im glad....thanks for everything bryan...

[Bryan Raffa]

no your ok