puttin a clutch in?

[mean350]

does anybody know how hard it is to put a clutch kit an a 85 350x. i just goty a magnum clutch kit and need to put ity in. i dont want to pay somone 200dollars to put it in either.:TrikesOwn

[xman23]

i put one in my 200x like a month ago and i thought it was preety easy, and i never replaced a clutch before, get a ownersmanual

[350Xhilaration]

Clutch isn't too difficult to replace.

I did mine before TrikeFest last year.

I'll yank the clucth replacement section of the manual for you and attch it here in a few.

If you do not have air tools, you can put the trike in 6th gear and hold the rear brake on to break the nut loose from the shaft. (you'll have to put the pedal back on (temporarily) after you remove it to get the side cover off).

Give me a few minutes to grab the clutch pages...

[mean350]

that would be graet!!! thanks alot

[350Xhilaration]

I'll PM you the link for the manual pages...limit for attachments is 100K...it's almost 10MB.

Give me a few to upload it...

[mean350]

what kind of air tools do i need? i have the motor out of the trike for a resto right now. so i dont have the brake or anything. lol

[350Xhilaration]

Link sent.

[DeePa]

you need to unstake the loc washer with a drill then use an impact to get the clutch hub nut off...

if you have AIM, aim me at m20deepa20 and ill send you the whole manual

mike

[mean350]

thanks 350xiliration for the manual for the clutch. also what kind of clutch did you put in urs? thanks again

[350Xhilaration]

You may need a 1/2" impact to get the nut loose that holds the clutch parts together.

http://www.350xriders.com/clutch.jpg
http://www.350xriders.com/clutch2.jpg
http://www.350xriders.com/clutch3.jpg
http://www.350xriders.com/clutch4.jpg

[350Xhilaration]

I used Vesrah fibers and steels and new Honda springs. I went with the Honda springs because I didn't want the super stiff pull of a "performance" clutch kit.

And my engine is stock so I didn't need super clamping power.

Did you download the manual ok?

[mean350]

yeh i downloaded it ok. you got a nice lookin x there. i seen it on 350xriders though. lol great site

[mean350]

how much were the honda springs? i might use them, instead of the magnum ones.

[350Xhilaration]

I can't remember exactly...have you downloaded the parts manual yet?
http://www.350xriders.com/cgi-bin/yabb/YaBB.pl?board=performance_board;action=display;num =1101861689

Grab it from there and find the part number you need and enter them at www.servicehonda.com or www.ronnies.com or just about any other honda parts dealer that has an online catalog.

[mean350]

im downloading uit right now. thanks for the help