banshee bearing carrier

[twgranger]

What year banshee bearing carrier bolts to the tri-z? 87-88 or 89 to present?

[Bryan Raffa]

none there wider... as far as i know....

[twgranger]

none there wider... as far as i know....Then how did 2extreme put one on his z??? Im not looking to put a carrier on im looking to see if the swinger extensions have the same bolt pattern.

[Mosh]

i have a z swingarm and a ton of banshee carriers. if ya give me a few days,i will research this as i want to do the same for my new z project. i am sure it will work.i think you have to use a 87-89 basnhee carrier. 2xtreme went thru a lot of fab work making a new aftermarket carrier work.i think the early banshee carriers are almost a bolt on deal.but i will have to check.

[twgranger]

i have a z swingarm and a ton of banshee carriers. if ya give me a few days,i will research this as i want to do the same for my new z project. i am sure it will work.i think you have to use a 87-89 basnhee carrier. 2xtreme went thru a lot of fab work making a new aftermarket carrier work.i think the early banshee carriers are almost a bolt on deal.but i will have to check.
Thanks, i just need to know if the bolt patterens are the same. The carrier dont have to fit.

[03 ORANGE SHEE]

i tried the old 87 two bolt carrier setup
it is wider but fits after you spread the mounting tabs...
and you have re drill the bottom hole , its off just a hair

[twgranger]

i tried the old 87 two bolt carrier setup
it is wider but fits after you spread the mounting tabs...
and you have re drill the bottom hole , its off just a hair
sounds good to me.:w00t: