110/125 carb

[team-red-rider]

i have a new carb body for a 110/125m but the idle screw is broken off in it.. the carb looks like brand new except a liltle dirt and dust..1st how could i removed a broken idle screew?? and how much is it worth if i get it out and clean the dirt and dust... its just on the out side inside is immaculate:wondering

[rally4x4racer]

try a backwards drill bit ( one that drills by turning left)

I dont think you could get over 50-60 out of it tho. I bought 5 of them one time on ebay for 35 :) - they were not very clean
r4r

[PymerOne]

Can you reach the idllescrew from inside the slidehousing (with a sleek plyers maybe)?
Use a few cycles of heath and cold on it before trying...the screw didnt break for no reason.

Goodluck, P1

[team-red-rider]

it broke because it was dropped on the bench

[atctim]

you can get brand new aftermarket carbs for around $50 for that machine. $30 tops in my book.

[hoser]

you can get brand new aftermarket carbs for around $50 for that machine. $30 tops in my book.

Where do you find these carbs?