rebuild time

[yourlossmygain]

ok iv got almost every thing i need to put the tecate engin back together. should i get a new wrist pin, and the pin to put in the crank shaft after i out the new connecting rod bearing on? i suppose its about time its been ripped apart since trike fest.

[jason 32]

if there is any play - yea
if not then its fine-
i would use a new berring at least

[yourlossmygain]

yeah im putting a new bearing on it. im not to sure if i need the pin though becuse when she blew up at trike fest the bits of the piston ate the hell out of all the bearings in the crank so i was just wondeing if i need it.

[jason 32]

are you talking about the big end rod berring then?- it should come with the kit- (the pin)
either way i would go ahead use it -- unless your positive the other one is ok-l
its a lot of work to say -(man i wish i had done it )

[yourlossmygain]

yeah thats what i was talking about i havent ordered the bearing yet and the pin is seperate on the list so i think ill order it any way. thx for the help.