gasket question for triz rebuild ****ASAP

[erikb45]

ok this might be a stupid question but i ordered a complete gasket kit for triz and there is no gasket for the main cases (crankshaft/tranny). there is supposed to be a gasket for that right?

theres also a little rubber oring where does that go?

[erikb45]

bump bumpbump

[SWIGIN]

most 2 strokes dont use a gasket on the main cases

id use some yama-bond

[MTS]

You need to use Yamabond/ semi drying liquid gasket on the center case of the gaskets, You can also use 1104 Liquid gasket, or Loctite Gasket eliminator....Need to coat all the surface's evenly and bolt it togther, Dont use too much as it makes a Big mess and You dont want pieces floating around in the bearings.

[erikb45]

ok thanks guys

[Bryan Raffa]

yea yamabond or 1104 works the best also permatex makes the same stuff for motorcycles and atv's that really good also!

the little o ring is for the oil filler cap..

[erikb45]

thanks raffa

[sblt500r]

make sure the case mating surface is clean. also don't buy a cheap gasket sealer, or a no name sealer. you don't need a leak and have to pull the engine all apart and start all over!