bottom cam chain sprocket removal on 200s

[84honda200s]

how do you take the bottom cam chain sprocket off the crank ? do i need some special tool ?

[84honda200s]

anything? i have a ride next weekend and i wont be going if i cant get this thing off and a new one in. the teeth are rounded off almost. thats probably why it kept jumping time.





please guys help me out a little bit here. i need some ideas how to get this thing off. i know where i can buy a new sprocket but i cant get this one off.

[84honda200s]

TTT please guys help me out.

[3 weelin geezer]

You are being snubbed, honda200.


No, really. My 185s has one that you just pull off with a gear puller. The book says it must be removed using a suitable puller. I think I used a valve spring compressor (and a shim for that longer puller arm) on that to be able to fit it from behind from Autozone.

[84honda200s]

sweet thanks man. yea i know im getting snubbed. ooo well.

[3 weelin geezer]

Just don't run away like ol AKPete did back around Hollow ween. To get it on, I just heated it on the stove until it was too hot to hold then I ran outside with it (use pliers...) and stuck it on there. Have a mallet and something like a socket or a pipe to whack it before it cools too much and grabs the shaft.

[84honda200s]

i thank you for not snubbing me. thanks a ton man.

[3 weelin geezer]

One more thing: Pay attention how the old one is in relation to that key slot. The tooth has to be lined up with it.

[84honda200s]

yea thats the only part i know about removing it.