what grab bars fit 84 250R

[yellowbeard]

Hey guys, is there other grab bars that fit my 84 250R? been checking old treads, no luck. been watching ebay. thanks Joe

[SYKO]

I have a PRM desert grab bar on my 83 that came off a 85R

[Meat-BoX]

They make a real sweet product.
http://prm-atv.com

[stealthduner]

They make a real sweet product.
http://prm-atv.com

They really do make a sweet part, very durable. I have them on all my 250R's

[ATCT]

Hey Joe--

Yeah, as far as I've seen, PRM has some decent after-market grab bars. However, if you want an original, just be patient on eBay. One will eventually turn up. I was looking for a stocker for my Tecate, and after a little over a month, I finally got one on eBay.

[Dirtcrasher]

I'll put the PRM a big step above "decent" and for 35$ your gonna pay close to it with shipping for an OEM crapper....

I am VERY happy with their products......

[brapp]

i can attest tothe prm bars they hold up i have broken a few dg ones and the prm one does take a bit more to break them i have only broke one so far and have 2 of them but i have built my own the last few years

[Dirtcrasher]

Don't forget, you WANT them to break to some extent. I've seen many frames ruined by homemade indestructible grab bars!!

[NINJA]

Don't forget, you WANT them to break to some extent. I've seen many frames ruined by homemade indestructible grab bars!!

What? you don't like busted off frame tabs?!

[Dirtcrasher]

What? you don't like busted off frame tabs?!

Frame tabs?! Hell, I've seen the whole rear subframe ruined and I know you have too ;)

[NINJA]

Frame tabs?! Hell, I've seen the whole rear subframe ruined and I know you have too ;)

Funny you should say that! My 86 200X that I have now, literally had it's rear subframe twisted up on the right side about a quarter of an inch because the genious who had it before me, no joke, had an indestructible grab bar that extended out about 18 inches! I think he built it as a wheelie bar:lol:

The DG alloy grab bars aren't bad, they're just pricey these days. I remember when they were 40 bucks retail. I think they look better than the PRMs. They're also still available for the 83/84Rs. But if you're going for value, then go with the PRMs.

[Huffa]

I have the baha one

http://prm-atv.com/MN.asp?pg=products&specific=181&from=38&mfr=2

and really like it, I (being picky here) just wish PRM would have made them sit about an inch higher so it's closer to the fender.

I may even have another section added below the original holes so I can do just that.

Just watch out if you get a 84R rear skid plate from them beause the rear holes are drilled wrong.