threewheelin-feelin
03-18-2008, 10:20 PM
Hhey guys i just installed a brand new clutch kit with spiring steels and fibers...i put it in last week and rode it around fine ...everything was good sunday ...well i went out to ride it yesturday first lap around and it was slipping really bad...so i took it apart and found that my two outer frictions looked like they has some type of crud on the out sides where they would touch the pressure plate...well i cleaned it off and put them back towards the inside of the clutch pack and moved two others to the outside....i also noticed the new springs i got were like a 1/8 inch shorter then my old ones so i put the old ones in...any of you guys had a problem like this? or think it was just because of the springs were shorter?