Plesase help

[hsstsss]

whats the best way to get a stuck bolt out its on my 200x i am trying to replace the clutch but it is stuckit on the clutch plates and also on the oil lpump

[freewheel3]

Any chance they are left hand thread?

[hsstsss]

i never thought of that i will try that

[freewheel3]

I'm not sure about the oil pump but some clutches have a left hand threads. Don't twist anything off finding out the wrong way.
First, maybe check an online parts schematic if you don't have a manual.
Or search for a manual on this site, maybe?

[hsstsss]

nope its not left hand thread

[jeopardy98]

Get the wrench set and whack it with a hammer a few times. Also you can try tightening it just enough to break it and then loosen it up.

[hsstsss]

ive tryed i cant get it out or breake losse with any thing ive tryed and impact driver and hiting it with a hammer and also penatrating oil

[hsstsss]

also i need to figure out someting to stop the gears from moving i tried a penny and it just crushed iot so i dont know what else to use so it wont breake the gears

[Russell 350X]

also i need to figure out someting to stop the gears from moving i tried a penny and it just crushed iot so i dont know what else to use so it wont breake the gears


Did you try putting it in gear first?

[SeaBass8]

Try using a small piece of copper pipe with one end flattend out to stop it from turning.