dies out after it warms up

[kilabeez0]

85 110. BRAND NEW top end, carb kit, lined gas tank, new lines. everything is new and mint. it'll run great for about maybe 10 minutes tops and then will die out. i can get it to barely idle if i blip the gas a little. otherwise it will die and not start for a few minutes. i think the float was sticking because at one point i had gas pouring out of the carb until i tapped it with a hammer. i just pulled it apart and cleaned it like 2 weeks ago AFTER rebuilding it so i dont get it. any ideas on what to check next? pull the carb again and go through it? i pulled the carb again 2 weeks ago because i noticed it had crap all over the outside, like maybe after i gave it a carb dip i didn't rinse it off good enough.

[DeePa]

fuel tank vent? next time it happens, pull the tank cap off, or go take the cap off when its cold, fire it up, and see if it dies out

[kilabeez0]

well it's funny because i thought that. i pulled the cap off when it was dying out and it still did the same thing.

[Erics350x]

clean the petcock and carb out real good, pull the jets and needle/seat and run wire through em to clear them good

[oscarmayer]

sounds like the float is not set correctly, or your needle is not setup right and your screw adjustment could be off.

[Dirtcrasher]

As soon as it dies, turn off the gas. Then either remove the fuel bowl or drain it if it has a drain screw and at least you can figure out that it's a fuel delivery problem.

[DIGGER DOG]

definately have to determine if it is fuel issue could be a bad ignition coil

[Twilight]

My 200x, Honda Gyro and Pilot all did this

Check the main jet.