stupid question

[bakeban]

this is going to sound stupid but does anyone have problems getting the drain plug out of thier 200x motor. i have to pretty much pull the motor to get the plug out. i was wondering if perhaps i have a slightly bent frame. thanks

[Howdy]

Never had a problem yet. Are you sure your pulling the right plug? If so you probably have a bent frame.
Howdy

[ATC crazy]

Or tweeked motor mounts :rolleyes:

[Coty]

the last time i drained my oil i had to lift it in the air and crawl under the thing, and then i was trying to put it back in for an hour when i realized i had to push the kickstarter down alittle to get in there, i don't know if something is screwed up on my x or what.... :-P

[slippy4]

never had a problem, just very annoying where it is located

[wanta250r]

Coty-you have to push the kick starter down. lol LOL You mean gear shifter. lol

[bakeban]

i have to take all the motor mounts loose and i leave the long bolt on the lower rear of the motor. i then have to get a prybar and pry the motor up to get the plug out. i think i will pull the motor completly next time and get jiggy with a sledge hammer :twisted: