1980 Honda ATC110, does anybody know...

[Autophysn]

If you can replace the original three lug hub with the later model four lug hub.
In otherwords, are the axles the same size and spline number?
I would like to do this to open up more tire combo possibilities, such as switching out from knobbies to paddles. Also, harder to find three lug aluminum rims. I know it is not impossible, but more expensive too cause they are rare.
:beer Thanks in advance

[oscarmayer]

you should be abble to on the rear yes. front would be a different story, you'd have to get a whoel fron assembly. if your going to do that, just switch to a 200s shocked fron setup and now you got a better lookin and ridin trike.

now i'm nort 100% on my answer but i think I did that a while back in the mid 90's when I used to do a lotta work on the 90/110's.

[redryder]

On my 110s I put 200x hubs on the rear. They match the splines. On the front I used a 200x front hub, an axle off of a later year 110 or 125. Had to make a couple spacers it works fine.:beer

[jason85atc250r]

for your 1980 atc 110 you can switch all the 4 lug stuff over from a 83 and newer atc 110. it'll bolt rite up.

i have all the stuff your need laying you will need. pm me if you interetsed and will discuss the deal