Got the 125M going today!

[Derek]

Well, I got my cylinder back back today its was getting bored .50 over. I also bought a cycle works piston. I got it all back together and running great. The only problem is when you hit the gas it wants to rev longer than it should like its sticking for about 3 secs in that throttle position. It will not do it with choke on and it will not do it with the idle screw backed all the way out. It will only do it when you adjust the screw inward for it to idle. Any ideas?

[daniel_250r]

its probably starving for fuel move the clip down one on your carb, sounds lean to me

[Derek]

its probably starving for fuel move the clip down one on your carb, sounds lean to me

Ok, I will try that tomorrow. Thank You

I also tried a different idle screw because I realized the original one was slightly bent but the same thing happened.

[daniel_250r]

if that doesn't clear things up you might have to get bigger jets

[Derek]

if that doesn't clear things up you might have to get bigger jets

Would it be because it is now bored over?

[daniel_250r]

most likely

[Derek]

Yep, someone had the clip in the uppermost position. I dropped it down to 1 under the stock position. Thanks for your help.